Home    
 


Bending and Round-bending Machine XZP 35
Bending and Round-bending Machine XZP 35
USE :
The machine is intended for the cold curving of bars, tubes and various other sections. They can even be curved in a helix.

MACHINE DESCRIPTION :
The curving machine consists of the actual curving head provided with two shafts supported by two tapered roller bearings. Both the shafts are driven by an electric motor through a gear set and a gearbox. The third pressure shaft is supported in the same manner in a sliding block which is pushed into the working position by a hydraulic jack. The body of the machine is made of steel including the hubs of the bearings. The head is provided with a plastic cover. To make helix-curved products, the machine is provided with two lateral pressure rollers. As the machine is mounted on a massive metal-sheet stand that enables the head to be adjusted both vertically and horizontally, its scope of use is considerably extended. Upon special request, the machine can be provided with a digital measuring device to measure the position of the pressure shaft. The machine includes a distribution box with a control panel and a double foot-operated switch with a STOP button. As there exist many different sections to be curved, the shaping rollers are supplied as specified in the particular order.

TECHNICAL DATA :
Pitch between the bottom shafts 265 mm
Diameter of the shafts 35 mm
Upper shaft traverse 100 mm
Electric motor output 750 W
Speed of the bottom shafts 6 (10) ot-1
Mains voltage and frequency (standard) 400 V/50 hz
Machine height 1650 mm
Machine length 685 mm
Machine width 600 mm
Machine weight 200 kg



Table of sections



  Table of sections